AP3155 Adhesion Promoter for Hard to Print Substrates; Glass, Alum, Arylic, Metal, 1-Liter Bottle (DO NOT SHIP BY AIR)

Application Instructions for UV and LED Curable Inks:

1. Wear protective gear including Latex or Nitrile gloves and safety glasses
2. Use in a well ventilated area
3. Apply AP3155 to the substrate with a clean, white, lint free wipe or microfiber cloth saturated with the promoter, covering the full surface and ensuring no voids
4. Using a clean, dry, white lint free wipe or microfiber cloth, wipe off AP3155, leaving a thin layer of promoter on the substrate (the substrate will feel slippery)
5. Load the AP3155 prepared substrate into the printer and print image using UV or LED curable ink
6. AP3155 will cure with the ink when flashed by the UV or LED lamp
7. AP3155 CAN BE SHIPPED VIA GROUND or AIR SERVICE

Paint Gun Application for UV Curable Inks:

1. Wear protective gear including Latex or Nitrile gloves and safety glasses
2. Use in a well ventilated area
3. Cut AP3155 with Acetone at a ratio of 50/50
4. Spray a thin even layer of AP3155 onto the substrate using a metal spray gun
   outfitted with a fine tip nozzle
5. Load the AP3155 prepared substrate into printer and print image using UV curable ink
6. AP3155 will cure with the ink when flashed by the UV lamp

Glass Special Instructions

1. When printing on glass only print on the float or tin side of the glass
2. To confirm the float or tin side, Illuminate the glass with a black light;
   the float or tin side of the glass will glow